Geoprocessingឧបករណ៍ដំណើរការ

Indian to WGS84 UTM Converter

បម្លែងស្រទាប់ពហុកោណរវាងប្រព័ន្ធកូអរដោនេ Indian 1960 / Indian datum ដែលប្រើក្នុងទិន្នន័យកាដាស្ត្រកម្ពុជាចាស់ និង WGS 1984 UTM ដោយអនុវត្តការបម្លែង datum ដែលសមស្របនឹងគូនោះ។

រកឃើញនៅឯណា
KGA Toolbox ▸ Geoprocessing ▸ CRS ▸ Indian to WGS84 UTM Converter

ទិដ្ឋភាពទូទៅ

Legacy parcel data recorded on the Indian datum will not overlay modern WGS 84 imagery correctly — the shift is tens to hundreds of metres. This tool performs the conversion with the correct transformation rather than a plain reprojection.

ការប្រើប្រាស់

  • Input Polygon Layer is the layer to convert. Its current coordinate system is read automatically and shown in Input Coordinate System, which is bound to the input layer.
  • Confirm Input Coordinate System before running. If the layer's metadata declares the wrong coordinate system — common in older shapefiles where the .prj file was copied from elsewhere — the conversion will silently produce wrong results. Set the declared coordinate system correctly first, using the Esri Define Projection tool (available on the ribbon from the CRS gallery), then run this tool.
  • Output Coordinate System is the target. For Cambodian work this is normally WGS 1984 UTM Zone 48N.
  • Reprojecting does not change the data's accuracy — it changes its frame of reference. A conversion cannot recover survey precision the original data never had.

ប៉ារ៉ាម៉ែត្រ

Parameters for Indian to WGS84 UTM Converter
ឈ្មោះប្រភេទទិន្នន័យការពិពណ៌នា
Input Polygon LayerFeature Layer

The layer to reproject.

Input Coordinate SystemSpatial Reference

The coordinate system the input data is currently in. Read from the input layer; confirm it matches reality before running.

Output Feature LayerFeature Class

The reprojected feature class to create.

Output Coordinate SystemSpatial Reference

The target coordinate system — typically WGS 1984 UTM Zone 48N for Cambodia.

របៀបប្រើ

  1. Add the legacy layer to the map.
  2. Check the layer's declared coordinate system in Layer Properties → Source. If it is wrong or missing, correct it with Define Projection before continuing.
  3. On the KGA Toolbox tab, in the Geoprocessing group, open the CRS gallery and click Indian to WGS84 UTM Converter.
  4. Set Input Polygon Layer. Confirm the value filled into Input Coordinate System.
  5. Set Output Feature Layer.
  6. Set Output Coordinate System to the target — for example, WGS 1984 UTM Zone 48N.
  7. Click Run, then overlay the result on satellite imagery to confirm it now registers correctly.

ព័ត៌មានអាជ្ញាបណ្ណ

Requires an active KGA Toolbox license. The tool validates the license before running.

ត្រឡប់ទៅឯកសារណែនាំ